The BL-Ctrl is programmed for use in the Hexa - or OktoKopter. It can be set to address 5-8. This it is a SMD-preassembled Brushless Motor Controller Kit, only one Capacitor has to be self-assembled. The board is tested and programmed (including bootloader) TECHNICAL DATA
• Integrated current measurement for measuring the actual current and the used capacity
• PCB: 4-layers (increased current-measuring shunt)
• Supply: (3s + 4s)
• Automatic Current limitation
• By high-performance MOSFETs 12A and 25A peak period are possible
• Two LEDs (e.g., OK and Error)
• Addressing the controller by jumper
• Various interfaces (I2C, PPM, serial)
• Bore: 3mm
• Dimension (W x H): approx 44mm x 21mm SCOPE OF DELIVERY
1x - SMD pre-assembled Board
1x - 330/25 Low Impedance Capacitor NOTES:
• This is a construction kit in which the SMD components are already preloaded.
• Parts required for the operation must still be equipped themselves.
• Only for private, non-commercial use.
• The controllers should be protected from moisture. Mikrokopter BL-Ctrl V1.2 Schematic, Connection, and Addressing